To hang heavy cabinet doors and to conceal the hardware, use mortised European-style hinges. Use a 35 mm drill bit and set your drill press to half inch depths. Place the holes a quarter inch from the door's edge and be careful, when you set the depth, not to drill through the door. Attach the hinge to the mortise, and then attach the door to the cabinet box. When the cabinets are installed, the hinges will be completely invisible.

Bob moves to the kitchen in the Melrose remodeling project and talks with Jay Martel from the International Association for Child Safety about kitchen safety for toddlers. Martel reviews new products that can help make the kitchen safe. Martel shows an adhesive latch to prevent a child from opeining the refrigerator. Martel then shows a product that magnetically latches cabinets and prevents pinching. When activated, cabinet doors will not open until a magnetic "key" is used. The product can be disengaged by adults with a flip of the switch. For stove safety, Martel recommends parents use the backburners with handles turned away to prevent children from spilling heated foods and liquids. Martel explains that dishtowels draped over the stove's oven handle often invite children to pull on them and should be removed to prevent an accident. Stove knob covers should also be put in place. Martel shows how electrical outlets can be replaced with sliding covers that automatically slide shut when electrical plugs are removed. Bob and Martel then move to the staircase to review baby safety gates that have been installed. Martel says nothing is more important for children's safety than installing gates at the tops of stairs. Martel shows how the swinging gate requires two motions to open, a squeezing action followed by lifting. Martel reviews how the gate has been properly installed with affixed mounting hardware and inswinging action.

Bob meets with Mark Van Sickle from Merillat who is installing hardware on the new semi-custom kitchen cabinets. The Merillat cabinet doors and face frames are solid cherry in a cider finish. The cabinet end panels can be specified by the homeowner or architect to either match the cabinet fronts or to be made of plywood. Mark has set up a drilling jig for drilling holes for hardware to keep all holes on the same 5-inch center. He shows us the contemporary profile stainless steel pulls that will be attached to the doors. This set of cabinets has an unusual setup; it consists of 3 wall cabinets stacked on top of each other and built up on a platform for a toekick. This is an unusual installation creating a whole wall of cabinets like a butler's pantry while saving money buy using standard overhead cabinets. Solid end panels will be added to cover the seams of the stacked cabinets. Bob and Mark move over to the other wall where they notice the orgonomics - the extra organizational features that can be added to cabinetry - including a built-in wastebasket, a pull-out for cooking oils, a sink tray for scouring pads and sponges, an under sink tote for cleaning supplies, and a dishtowel holder. The pantry unit also incorporates orgonomics with slide-out wire baskets that are easy to install and adjustable to different heights - perfect for dry goods, cans, and cereal.