Some cabinet makers claim that the band saw is the single most impotant stationary tool in the workshop, because the blade circulates like a ribbon, it allows you to make curved cuts for chair seats or round table tops. The bandsaw is ideal for cutting lumber of considerable thinkness. You can even stack seval pieces to make identical cuts to save time.

Bob meets with Michael Shiels to discuss the progress on the modular home project�s exterior construction. Bob points out some of the features that give this home its custom built exterior feel, including Cedar clapboard shingles on the lower half and Cedar shake shingles on the upper portion of the exterior walls areas as well as steel roofing. Cedar shakes are applied as a panel to the exterior of the house. Ken Clark from Cedar Valley Shingle is on location to demonstrate the installation of these panels and explain how they are produced at the factory for quick installation at the home site. At the factory, two-foot-by eight-foot plywood sheets are laid out and band saw cut, kiln dried, Western Red Cedar shingles are stapled and glued to the sheet. The band saw cutting process increases the open grain on the wood and allows for a better penetration of stains and sealers to extend the life of the shingle. The plywood backing increases the �dead� air space and increases the insulating value of plain cedar. The corners are made at the factory to conserve time and materials at the job site. The interlocking panels and pre-constructed corners can shave 75 percent off the install time of standard shakes. The shingles are also available pre-finished.

Using a jig is a great way to make accurate, angled cuts.