Your home's ability to resist the extreme force of wind is only as strong as its weakest link, so the only sure way to create a wind-resistant home is to secure all its connections: roof-to-wall, floor-to-floor and wall-to-foundation. The roof is your home's first line of defense from a storm. To make sure the roof stays in place when severe winds blow, securely anchor roof-to-wall connections by installing hurricane straps or clips at every wall-to-rafter connection to reinforce the roof. Even if re-roofing your existing home is years away, it is possible for roofing professionals to access and reinforce an existing home's roof-to-wall connections with hurricane straps and clips. These connections are critical in holding the roof together and will dramatically increase the homes overall resistance to wind. Along with roof-to-wall connections -- all joints in the structure -- floor-to-floor and wall-to-foundation -- must also be secured to create a "continuous load path" to the building's foundation. Secure floor-to-floor connections by making sure each floor is connected to the floor below with straps or clips in addition to any other code-required nailing schedule. Wall-to-foundation connections should be made through the use of anchor bolts or mud-sill anchors. Be sure to install all connectors following manufacturer's specifications.

Dress up the rooms in your house with a variety of custom moldings. These moldings are available in many historic profiles. You can add a one piece baseboard molding for a 19th century look. Poplar chair rails and picture moldings add detail and take paint well. And for a more elegant look add a multi-piece crown molding to the ceiling.

Here are some things to think about when you're hanging your own kitchen cabinets. Hang your upper cabinets first, so the lower cabinets won't be in the way. Snap a level chalk line to align the countertops. Use shim shingles to level them, then use drywall screws to secure your cabinets to the wall studs.

When hanging wallboard on an angle, try this technique. Measure the length from the edge of the wall to the end of the angle. Next, measure the height - think of it as outlining a triangle. Mark the measurements on your wallboard and snap a chalkline.

…Bob Vila Constructing a Porch Trellis Season 2 Painting a Stucco and Wood Exterior Season 2 Western Red Cedar Trim and Boards Season 2 Installing Western Red Cedar Decking Season 1 Expanded Outdoor Living Season 1 More about…

…Sealant • Combines the performance characteristics of silicone and polyurethane • Apply around doors, windows, trim, siding, countertops and other projects White Lightning® All Purpose MEGALASTIC Super Elastic Sealant • Provides…

…the trunk. Step 5: Use a pole saw to trim large trees. The best tool for trimming…
…also has a lopper feature. Step 6: Trim dead branches from taller trees with the…
…professional. It is never a good idea to trim branches from a ladder. Stand back…

…door casing has been milled off-site and each trim section is comprised of two pieces. The inside…
…or back band, slips neatly over the inside trim for a beautiful look. Unlike traditional trim that meets in the corners at a 45 degree angle…

…trimming the rafter ends with pine, the Habitat crew is using L-P's SmartStart Fascia and then finishing it off with SmartStart Trim. SmartSystem products replicate the appearance of solid wood with added performance benefits. They have an engineered wood…

The architect's design for the back porch called for some beefed up columns to complement the large overhang. To accomplish this Bob and Ryley built out 6x6 columns with 3/4" stock and 1 1/2" pine 1x8s and trimmed the top and base.