Chapters from this episode
Now Playing
Clip Transcript For:
Installing a Casement Window
computer-generated transcript - may not be 100% accurate
" Now this window goes in that rough opening over there."
" The rough opening here, yes."
" And this is a very unusual casement window 'cause usually crank outs don't give you that much width do they?"
" Well this is a specially built window, not only does it have the width but it had the radius tend here, this is a flat arch radius."
" Yes, it's part of the architectural design."
" That's correct."
" The finish is a special finish."
" The type of polymer paint that they use, it's actually right over the wood surface."
" Okay."
" And some peacock blue imaginative house."
" It's a neat color and that goes in this rough opening over here."
" That's gonna go over something like here."
" Okay, now you've got again an unusual condition here where we needed to create more depth so that we could have the right detailing on the plaster on the outside. So we have regular 2 by 4 construction then furred out with 2 by 3 metal stud."
" That's correct."
" And that's a nice little trick up here."
" It's got a little radius, that'll match the radius on the head of the windows."
" Looks like you're ready to go."
" Are you willing to give me a hand?"
" Sure."
" Let's do it."
" I should stand this end right?"
" Yes."
" Not too heavy."
" They have..."
" Now does this craft paper have to stay on?"
" This is a side of that flashing. They also have these little tabs that we use for installation that we need to get..."
" Turned out."
" Had in, yeah. It gonna be sort of a tough to work with here."
" And you gotta bend them a little."
" Okay, I'm ready to go."
" Okay."
" Okay I got to come to you."
" There we go."
" Good, why don't you go in the inside and fasten it."
" Okay, you got it."
" Okay."
" I'm gonna check the reveal here."
" Okay that takes care of the size, now what about the radius up there how do you fasten it here?"
" Well they have the little arches that we've already pre-fab, stick those up well you."
" Let me see that, you just went trace around the outside of the framing."
" What we did is we nailed a piece of plywood. Screw a piece of plywood to the frame."
" Yeah."
" Grab the arch, cut that out, and put it together."
" Now this is again just rough framing but, let me tap it with hammer."
" And the tab goes up here."
" Now how do you make sure that your window is plumb, or did you already take care of that?"
" Well, I checked the opening part to it, but what we'll do is we'll cross sight it. You wanna put this in for me."
" You got to tap it with your hammer there to get it snug, there you go."
" So in other words you've already made sure that your plumbing level when you were furring out."
" Right. But one of the important things you need to do on all windows, you need to cross sight, or cross measure them, cross tape them."
" Yes."
" And you go from the corner."
" Make sure it hasn't racked."
" To corner. We have 73 inches there. And to this corner it's exactly 73."
" Good."
" So we're good."
" Let's see how it works."
" There it is."
" Nice."