Home > Video Channel > Installing the Whole House Electrical Surge Protector and Arc Detector

Installing the Whole House Electrical Surge Protector and Arc Detector

Barry Driscoll is in the basement installing a state-of-the-art surge protector from Square D. Barry hooks up a main surge protector for the whole house that will take care of all the appliances, electronics, and anything else that could be damaged. It also protects the telephones and cable TV that run throughout the house. This eliminates the need for individual surge protectors on separate appliances. This can be installed in a retrofit as well as in new construction. Barry is also installing an arc fault detector. These units that are now required by the new national electrical code for branch circuits in bedrooms protect against fires from arcing caused by damaged wires (if you hit a wire while hanging a picture), deteriorating electrical insulation, stressed electrical cords, or misapplied or damaged appliance use. The arc detector was designed to detect overloads, short circuits and arc faults and open the circuit and stop the arc fault and its high intensity heat before a fire is likely to ignite.
Get Adobe Flash Player to see this content.

Clip Transcript For:

Installing the Whole House Electrical Surge Protector and Arc Detector

  computer-generated transcript - may not be 100% accurate

" All right so very that that the big things that homeowners with as much electronics as we have here have to worry about. Art surge protection right that's right and what are you doing there when you hooking up. "

" I'm hooking up a main surge suppressor for the whole house --"

" Take care of all our appliances -- TVs are stereo equipment. Than anything else that we'd be worried about damaging it's also gonna protect our telephones and our cable TV which run throughout the house wow so."

" This means anything plugged in anywhere in the house. You don't have to have an individual surge protector at that point -- use as a war. That's correct this'll be the whole entire house and is this of the you can only put in new construction or can you retrofit it you could retrofit and you could put this in any application. There it is green light who makes now we've -- by square DOK now what about arc detect that's one thing we're gonna be hooking up right now this wire goes up to a bedroom. And these which are going to be. Required in the new code. -- an arc fault detector that's gonna protect anything in our bedrooms. -- your child plugging anything into an outlet that he's not supposed to do while the connector. Make sure that if a kid sticks a key into receptacles we can't get shocked correct or if you hang a picture and you hit a wire. Anything that would cause a problem with your wiring will shut that right down and make sure it's safe to this and a lot of expense."

 [-]


More Videos »Related Videos

An Overview of the Home's Structured Wiring System
An Overview of the Home's Structured Wiring System

Bob and Tim Woods from the Internet Home Alliance meet in the kitchen. Tim details the Home Director structured wiring installation in every room, allowing the homeowner to stay connected to both the Internet and in-home control functions throughout the house. On the Panasonic flat screen LCD TV you can watch normal cable television or monitor outside security cameras. All the structured wiring is connected to the outside world thought a Panasonic Gateway. Woods also demonstrates a wireless Web tablet on which the homeowner can control home audio, heating & cooling, lighting, security, and telephones.

Residential Electrical Wiring for the Warehouse Rehab
Residential Electrical Wiring for the Warehouse Rehab

In this segment Bob meets Eddie Fisher, the master electrician on the Brooklyn project's infrastructure team. The team of five electricians from AC/DC Electric is rewiring the building from basement to roof deck. Fisher's team is pre-wiring the building for telephones, computer and cable TV. New York City building codes often require the use of materials and techniques not often seen in residential construction. Codes enacted in the summer of 2003 in New York City require a separate power line from the main electrical box to each GFI (Ground Fault Interrupt) circuit. Also required by code in this building is the use of BX, or metal-shielded, cable. BX is a rigid, flexible metal conduit with a wire bundle, consisting of individually insulated conductors covered by a flexible spiral-wound layer of metal. BX will typically last longer than vinyl-clad cable and may prevent some inadvertent damage in the future.

Call-In Access
Call-In Access

A Honeywell thermostat, in combination with the company's Telephone Access Module (installed in the basement or a utility closet), allows homeowners to dial into a home's HVAC system via telephone and make adjustments remotely.

Structured Wiring Installed
Structured Wiring Installed

Bob meets Tim Woods from the Internet Home Alliance at the Home Director network connection center in the basement. It's where all the structured wiring comes in and where the main controls happen: 2 +2 (cat-5 and RJ), cable broadband, security link-up, telephone, etc. Because the homeowners are a dual career couple they need to be connected to each other (home office to the studio) and to the outside world in a broadband environment. In the kitchen Larry Hicks of Home Director is installing some cable for a universal 2 + 2 outlet for TV, telephone or data near the breakfast nook providing flexibility for use of a phone, screen, etc. Looking at the Alliance's wiring plan, Tim points out the security camera at the front door and the ADT iCenter security system. The study/screening room will be a real media center with speakers for dolby stereo running through the ceiling, cable broadband, and a Panasonic high definition TV. There willl be speakers throughout the house allowing different music to play in diffferent rooms all controlled from the audio center in the kitchen. The Cisco Aironet system is a wireless network for the home allowing the homeowner to put a wireless card into his laptop and wirelessly port the web anywhere in the house. Because this is an old house in which they are trying to preserve the original plaster and lath walls, the installation of the structured wiring has required different tools and is a much slower process than in new construction, but it can be done.

Related Products & Services Showrooms

Clean, Quiet, Efficient Heating
Clean, Quiet, Efficient Heating

…Free (888) 773-4564. Benefits of Radiant Heat · Highest level of heating · Comfort · Easily installed in new construction · Accommodates any floor covering · Lower operating costs due to lower system water temperatures · No ducts fans…

More Content »More Content

Hooking Up Home Theater
Hooking Up Home Theater

Tim Woods from Internet Home Alliance looks at the features and benefits of planning home entertainment systems before you build your home.

Electrical/Surge Suppressor

Should I use a surge suppressor to protect my treadmill? In the past I have had numerous problems…
…new dedicated 15 amp circuit just for this machine - would a surge protector be overkill? If not, how many joules of protection do you…

Creating Your Ideal Home Theater
Creating Your Ideal Home Theater

…s always ideal to either work with a client on a new construction, or be able to have the budget to take a room down…
…your electric system. Investing in a whole-house surge protector and making sure you hire a licensed technician may…

Electrical Maintenance and Upgrades
Electrical Maintenance and Upgrades

…type of GFCI. In new construction, these are required…
…power to bedrooms in new construction. The updated 2008…
…extend the range of a surge protector. Surge protectors…
…of-the-art surge protector from Square D…

Browse Topics

Click on a letter to browse content by topic alphabetically.



About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© BobVila.com 2009