Interior designer Leslie Curtis shows off another of her decorating ideas in the dining room. She's chosen to frame a sample of an historic wallpaper pattern. The frames were created by Ron and Tracy Lindholm from Cape Cod Picture Framing. Bob joins Ron and his daughter Tracy in the garage workshop to learn about the process. The first step is to choose moldings that will allow the creation of a rabbet that will hold the glass and the picture. Ron selected a few examples from a local lumberyard. Next, he combines two of the pieces using wood glue and a few nails. After cutting the moldings, he uses a corner clamp to hold the pieces together at a 45 degree angle. To secure the pieces, Ron applies carpenter's glue and a few nails. Once the frame is assembled, Tracy applies an antique finish. After priming the bare wood, she applies two or three coats of gold spray paint. Next, she mixes a combination of paste wax and pigment, such as Japan paint, to age the newly painted surface. Using a damp brush, she stipples a thin layer of the finish on the frame and then wipes away the excess to create highlights.

Interior carpenter John Kiley is hard at work on the staircase in the front hall. The pre-cut risers have already been hung, and he's measured the rise and the run of the stairs. Kiley hangs the poplar stringers, which have been plowed to receive the treads. Kiley applies a bead of glue to the back, and then screws them in from behind. Once the stringers are attached, the whole staircase is ready to slide into place. Next, the treads are attached. Kiley uses a construction adhesive between the stringers and the bottom of the tread and carpenter's glue along the edge of the stringers. The treads are placed on top and nailed into the riser from above and then screwed with 1-1/4-inch screws from the back. The final step is to insert wedges underneath to insure the staircase remains sturdy.

Here's a technique professional carpenters use to conceal nails or screws: use wooden plugs. Use a dowel bit to drill out the plugs. Dip each plug in carpenter's glue, and tap it into place over the nail or screw. Let the glue dry, then shear the plug off with a wood chisel. Sand the suface smooth and apply your finish.

Bob shows the plan for the handcrafted medicine cabinet and Ryley shows Bob the wood that will be used in its construction. Ryley cuts the main pieces with a radial arm saw at one time to make later assembly go faster. He then plows out a rabbit for the top and bottom of the cabinet into the sides using a Dado blade. Ryley employs a router to plow out an area of the sides to make the standards flush with the sides. The standards will allow the interior shelves to be adjustable. Ryley then finishes off the cabinet construction with screws and carpenter�s glue.

…rim joists, basements, pipe insulation and much more with Foam it Green. The spray foam creates a barrier that blocks outside air, moisture, pests and rodents from coming in. Foam It Green 602 The Foam it Green 602 kit pictured here provides 602…

…water and weather conditions. • Outside: it helps protect areas around windows…
…temperature extremes so they perform well outside. Check out White Lightning's comprehensive…
…caulk windows & doors on the inside AND outside. • Check around your home's foundation…

The first addition to the sunroom in the Season 13 Modern Colonial home was a simple cedar planter. Built by Bob Ryley in the project house's workshop, the planter…

Many times the homeowner's only regret is that the sunspace is not larger. Although aesthetics often drive the decision to add a sunspace or include one in a new home design, sunspaces can also provide supplemental space heating and a healthy environment for plants and people.

In general, a south-facing orientation, within 30 east or west of true south, will provide around 90% of the maximum static solar collection potential.