Home > Video Channel > Converting an Unfinished Basement into Living Space

Converting an Unfinished Basement into Living Space

The crew from Owens Corning Basement Finishing Systems has been at work putting up the framework for the walls and the grid for the ceiling. The first step was to lay out the steel-stud wall just to the inside of the perimeter drain. The bottom sheet metal track was attached to the foundation using concrete nails. Magnetic levels were used to get a plumb line to the ceiling joists to mark where the top track should go. The top tracks were then screwed into the ceiling joists. The studs are cut to length and two studs are attached together back-to-back and then affixed to the bottom plates. The magnetic level is again used to find plumblines to attach the studs to the top track. The room will eventually be used as a family playroom. A suspended ceiling system is attached to the existing joists with wires so it can later be adjusted for level.
Get Adobe Flash Player to see this content.

Clip Transcript For:

Converting an Unfinished Basement into Living Space

  computer-generated transcript - may not be 100% accurate

" I know right now we've got the guys from Owens Corning basement finishing systems who have been busy inside working on putting up the framework for the walls as well as the grid for the ceiling let's check in. The first step was to lay out the steel stud wall just inside the perimeter drain and allow bump out for the mechanicals that couldn't be moved by the water meter and the waste stack. The bottom sheet metal track is attached to the slab by drilling a pilot hole and pounding in concrete nails specially designed for this. Once the bottom track was in Federico used two magnetic levels stuck together to get a plumb line to the ceiling joists and mark off where the top track should go. That's kind of a neat trick since it's hard to find a level that reaches floor to ceiling. The top track's just screwed into the ceiling -- it doesn't have to be level since it'll be hidden by the dropped ceiling. The steel studs are actually doubled up in the basement finishing system to provide a good surface for the -- which will see later. Affinity Coke cuts the studs to length. Since -- screws them together back to back and installs them sixteen inches on center before screwing them into the bottom -- The magnetic level comes in handy again as he adjusts the studs at the top for plumb and attaches them. It's an efficient way to frame the walls and because that steal the framing won't be affected by any moisture. That still gets into the cavity between the old walls and the new and it won't be providing food for mold. The area will eventually be a nice place to house an entertainment center and Federico and his son Marco did a great job framing it out symmetrical -- between the two front windows. Once the walls were framed the ceiling was next. Owens Corning uses a suspended ceiling system that's attached to the existing joists with wires so that it can be adjusted for level. Those old joists were never meant to provide a ceiling and they're way off."

 [-]


More Videos »Related Videos

Installing the Concrete Cellar Stairs
Installing the Concrete Cellar Stairs

Back on site, pre-cast concrete cellar stairs, fabricated in Williston, Vermont, are lowered with a boom and bolted up against the house foundation. The stairs, which weigh a good ton, are bolted on with 4 3/4" bolts and waterproofed with a neoprene seal. When finished they will have a metal bulkhead door on top and a door into the basement below.

Installing Custom Shower Doors and Bath Hardware and CO Detector
Installing Custom Shower Doors and Bath Hardware and CO Detector

Bob meets with Greg VanGrover of Ketcham Reflections to observe the finishing touches in the bathroom shower. VanGrover works with architectural drawings to custom fit the shower doors and glass walls. In older homes his factory-trained installers make a site visit prior to fabrication to insure the space is plumb and level. If its not his team will make the piece to fit whole so once its made the installer is not trying to fit a square peg into a round hole. Downstairs Bob meets with Barry Driscoll, the electrician to discuss the importance of Carbon Monoxide detectors. In the basement Bob shows off his mini Wine Cellar with a Marvel Cellarette. Also in the basement is a Wood Waiter from Bruce Fowler Industries of Quebec, Canada. This nifty device saves your back from having to haul wood from the basement to the main floor. This wood elevator transports wood from a basement storage area to a cabinet near the fireplace.

Steel Bulkhead Doors
Steel Bulkhead Doors

A steel bulkhead door can be a great addition to a home. To install, a steel frame is lowered onto the pre cast cellar stairs. Next, pilot holes are drill into the concrete and the steel frame is bolted down. The door and latching hardware are attached, providing secure and weather tight basement access.

A Complete Basement Remodel
A Complete Basement Remodel

The new family room is all done and furnished and looks terrrific. Bob talks with Sarah Monzon, the homeowner who also acted as the general contractor on the project, about the remodeling work done on the room. The room was a "cave" according to Monzon before the project was started. A pitted soapstone sink was previously used as a laundry and had become an eyesore. The room was also cluttered with accumulated junk. Because of the shortage of space in the house, the family decided to finish the basement to add to the living space of the home. Monzon acted as the general contractor for the project because there wasn't money budgeted for the expense, which was not necessarily an experience she would choose to repeat. The local inspectional services department provided a large amount of information for the novice general contractor. It is imperative before homeowners do any work on their home that they obtain the necessary permits and find out what is safe and what is not. If homeowners do work on their homes without a permit and anything goes wrong, insurance will not cover the damage. Before any work was done on the house, the basement floors were concrete and heating ducts crisscrossed the ceiling. There was flooding damage in the basement during the past fall which needed to be corrected and prevented in the future. Basement Systems was called in to install a perimeter drain and drainage system. A lot of existing plumbing was then moved from the ceiling to make more headspace and a new HVAC system was installed to move the heating ducts. The new central air system complete with an air filter made the house much more livable. In one of the smaller spaces in the basement, a new bathroom was installed with the help of technology from Saniflo. Owens Corning Basement Finishing Systems was then called in to install new finished walls. Many of the mechanical devices in the basement are now hidden behind the walls but are still accessible as the walls can be easily removed. A new entertainment center was then installed in the finished basement featuring a S1 Digital Media Center. The media center allows the homeowner to browse digital pictures taken using the family's digital camera or to set the image as wallpaper for the screen. Television shows can be watched or recorded using a schedule guide. The media center also can store home videos, movies, and music. New reclining chairs from Bell'O were put in the entertainment room. When laying protection from flood damage in a basement, it is important to elevate wood from the concrete floor. Instead of using a plywood underlayment, a plastic tile system was used which interlocks and can be screwed down onto the concrete. Plastic webbing underneath the tiles diverts any water which may come up through the concrete or spill in the basement to the perimeter drain. Slide-Lok cabinets were put in the basement to increase storage space. The Slide-Lok wall system was put in place to hang tools in the workspace. The husband of the family is a musician and uses much of the storage space to hold his instruments. Because the room can double as rehearsal space, two and a half inches of fiberglass are in the walls to reduce sound transmission to the outside. The basement has a small office space for the husband as well. Accents throughout the space correlate with other things in the room. The lampshades on the desk have a design which relates to the flooring product. The floor does not have a wall-to-wall carpet although it looks as if it does. The floor is from Binvetec and features tiles of carpet which stick to the floor. The product has interlocking patterns which can easily be layed down. Bean bags from Sumo were put in the room for lounging in and the kids love to play on them. A stairwell fishtank from AquaVista is only four inches deep.

Related Products & Services Showrooms

Do It Yourself Spray Foam Insulation
Do It Yourself Spray Foam Insulation

…your home is now healthier, more comfortable, and less expensive to heat and cool. Ceiling Spray You can do attics, crawlspaces, walls, rim joists, basements, pipe insulation and much more with Foam it Green. The spray foam creates…

Cool Your Home with a Whole House Fan
Cool Your Home with a Whole House Fan

…in an attic, flush with the ceiling of the house. When outside…
…a large open whole in your ceiling. Moreover, these larger fans…
…require you to cut your attic joists. Our fans are designed so…
…standard 16" and 24" on center joists, making for easy installation…

More Content »More Content

Owens Corning Basement Finishing System

…hardware, they plop in place and they plop back off. There is ceiling and floor trim, either white or wood grain, which is can…
…they plop off and then back. There is an armstrong suspended ceiling with can lights and intregal wiring/switches/outlets…

Owens Corning Basement System - Paintable?

Hi... I just saw a commercial about the Owens Corning basement finishing system, and it looks great... I'm just wondering if the surfaces are paintable like regular drywall? Anyone have any experience with this product? Thanks!

Sq. Ft. cost for Owens Corning Basement System

Does anyone know an aprox. cost/sq. ft. for the Owens Corning Basement System. I read somewhear it should be between $25-$35/sq. ft. My local authorized intsaller is telling me its more like $50/sq. ft. which I find absurd!

Engineered Wood I-Joists
Engineered Wood I-Joists

…off-site with engineered wood I-joists from Willamette Industries providing…
…flexibility. Moreover, these I-joists are resource friendly utilizing 50% less wood fiber than traditional lumber joists. The flooring system, called…

Browse Topics

Click on a letter to browse content by topic alphabetically.



About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© BobVila.com 2009