Home > Video Channel > Building a Deck and Stairs

Building a Deck and Stairs

Bob meets with Bill Wilcox to build a landing and steps up to the French doors. Bob reviews the footings built to hold the deck and stairs, and the techniques used to fasten the box to the house.
Get Adobe Flash Player to see this content.

Chapters from this episode

Clip Transcript For:

Building a Deck and Stairs

  computer-generated transcript - may not be 100% accurate

" this is building a set of steps towards that'll be the whole width of the of the area -- that's right and up the corner. And a few days ago you get started little concrete work right that's true we're putting the -- but the girl on top of those how deep to those -- four feet below grade. So that we don't have to worry about frost heaves that and then what are we looking at here with our grade -- Bob and it's roughly eighteen inches down reinforce. With the stairs so that how many stringer risers Wetherbee will be -- three right three steps down. Okay and then on the house itself. You got them blocks that you used to attach what you call these great book reads blocks right. They will prevent the water from reasoning in and causing damage to the side siting of the house. And will be able to put the the the whole box that you've built up against what the first step up. Well we'll take our guard here don't put on top. And we've ever had in the -- is doubled up two by twelve. Right right and ends and so you've got essentially a four by ten. Now. And there. Laid down. And when they. You know it's called back and makes him. This is almost a small version of a backyard deck which is of course the -- there but bill why not build in place why did you pre -- Well it's a lot stronger Bob the Builder hat -- you can nail back here as well as -- stands on it and as little more efficient and time -- Quaker. Let me give you."

" Connect it."

" right place so that the pneumonia. You. Nail it by this temporary. The real support comes from the lag -- The lag bolts are galvanized and there are six inches so they'll go through the reason block and into the frame of the house. So what do the numbers bill. Well while overall rise here point nine inches and are run out years 33 and we're going to take a piece of two by twelve pressure treated lumber. And turn it into what is known as a stringer which is the structure for the steps now now. How do you you know how do you figure out what the dimensions of the steps will be well -- comfortable rises about seven and a half inches that we advise them what we have here by war not with a -- quarter inch -- yet step up. And the 33 was divided out when that eleven inch run against and that's very comfortable for you what we'll have the eleven inches and only have declined seven and one."

 [-]


More Videos »Related Videos

How to Build a Deck Storage Box, Part Two
How to Build a Deck Storage Box, Part Two

Building a western red cedar deck storage box is a one-day project that will provide convenient storage and an extra place to sit. Western red cedar was chosen for this project because of its beauty and natural abilities to stand up to harsh weather and insects for many years. In Part Two of the project, the box itself will be built. Download PDF Plans View Part One

How to Replace a Damaged Deck Board
How to Replace a Damaged Deck Board

Wood decks can weather, crack and splinter. Use these steps to replace a damaged deck board.

Deck Building
Deck Building

Here are some basic things to remember when building your own deck. Attach the joist hangers 16 inches apart on center to the side rails. Assemble all floor joists and side rails before nailing. Then, nail all at once, using galvanizd nails. Overhang the first floor board by half an inch using galvanized finish nails. If you have an enclosed deck or a screened porch you can use tongue and groove flooring.

Anchoring a Deck
Anchoring a Deck

If you're building a backyard deck, you want to be sure it's secure on its foundation. Set a threaded bolt into your concrete footing. Then attach a post anchor base. Adjust it to receive your deck post. Use a washer and nut to secure the base. Finally, cover with a base plate. This will protect the porch post from rot.

More Content »More Content

#2 Pressure Treated Lumber

…structure of a deck) We treat both #1 and #2 Southern Yellow Pine at my plant. Since SYP makes up most of the pressure-treated lumber that's produced in the US, it's a good bet that BrianZ will be using SYP. That said, there is a distinct visual…

#2 Pressure Treated Lumber

I am rebuilding my deck and have had some contractors state that they would use #2 pressure treated decking lumber instead of #1. What is the difference between these two grades of lumber?

Flashing Over the New Type Pressure Treated Lumber?

…I have (2) questions: (1) It is my understanding that you cannot flash directly over the new style Pressure Treated Lumber with Aluminum Flashing, as the HIGH Alkaline content of the new formulation will corrode the aluminum. How…

60-Minute Home Improvement Projects
60-Minute Home Improvement Projects

…contractor who hosts the DIY Network program, Talk2DIY Home Improvement. All you need are eight, 8-foot long sections of pressure-treated lumber, screws, construction adhesive and landscape adhesive. With a drill and a saw, you simply cut pieces to size and…

Browse Topics

Click on a letter to browse content by topic alphabetically.



About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© BobVila.com 2009