Here s another great tip from BobVila.com. If your pipes are whistling, banging or knocking when you turn the water on or off, there are things you can do to quiet them. Water hammer is a common cause of banging pipes. In plumbing where water pressure is high, shutting off the tap can cause the pressure to back up and jolt the pipe, a little like slamming on the brakes in your car. The jolt can be especially violent when a solenoid-controlled appliance like a washer or dishwasher shuts the tap since the shutoff happens instantaneously. Many homes come already equipped with water hammer arresters, which are small air chambers attached above the water line to absorb the pressure of the water as it s shut off. Spiral-shaped water hammer arresters were also used years ago and you may still find them in older homes. Plumbing that s not properly anchored to the framing can rub or bang on whatever is nearby and cause a racket. All this banging and jolting can strain pipes and copper fittings and you can eventually wind up with a leak. It s best to deal with the cause of the noise wherever you have access to the plumbing. Plastic or nylon pipe inserts work well to cushion pipes running through framing members, but they need to be installed when you do the plumbing. For retrofitting, try pipe hangers. These plastic hooks hold the pipe off the framing and have a felt or rubber cushion to absorb any movement and prevent noise. Whistling sounds are also common where a shutoff valve hasn t been opened all the way or where pressure is high. If your water pressure is excessively high, installing a pressure-reducing valve near the water meter will get rid of the noise and lower your water bill. But consult a plumber first to be sure it won t take too much pressure away from any upper story plumbing. Find out more at BobVila.com: the ultimate home improvement web site! 2008 BobVila.com

When water supply pipes freeze, first restore home heat to the area. Start working on the supply side and leave a faucet open so you can tell when a flow starts. Pour boiling water over cloth wrapped around the pipe, or use a heat gun, heat lamp, or electrical heating tape. Avoid propane torches: their concentrated heat may cause pipes to burst.

First use fine sandpaper to clean the inside of the fitting and the ends of the pipe. Then brush flux onto your fitting. Join the pipes together and use a propane torch to heat the fitting, not the pipe; that pulls the solder into the joint. If the copper turns black, it's too hot. Now, wipe off the excess, and that's all there is to it.