…circulate into the enclosure. Keep cabinet doors open to allow warm air around the pipes. Step 6: Protecting a pipe: Wrap the pipe in heating tape. For pipes subjected to extended freezing temperatures, use electrical heating tape. Following…

Jump To: How To Library » Plumbing » Pipes, Drains & Fittings

…jacket in place. Step 2: Cover the pipes with foam insulation. Use snap-on foam insulation to cover the exposed hot water pipes in the basement. Use a utility knife to…
…ends at an angle to cover any turns in the pipes. Make sure all ends of the foam pieces…

Jump To: How To Library » HVAC » Insulation

…circumference of one inch of pipe until it is shiny. Do this for both pipes. You might consider using…
…oxide from the copper pipe. These tools have wire…
…Step 7: Solder the new pipe and coupling. Once you're satisfied that the pipes will fit, disassemble…

Jump To: How To Library » Plumbing » Pipes, Drains & Fittings

…Step 3: Clear the trap and pipes with a plumber's snake Push a plumber's snake up both pipes through the clean-out plug…
…s snake up both ends of the pipe to clear blockage. Step…
…nut on the back of the drain pipe and pull the control rod out…

Jump To: How To Library » Plumbing » Pipes, Drains & Fittings

…plumber for final connections. Belowground Water and Waste Pipes For some homes, moving belowgrade bathroom waste to the…
…slab to dig the hole for the unit, as well as any drainage pipes from additional basement fixtures, will set the homeowner back…

Jump To: How To Library » Plumbing » Pipes, Drains & Fittings

…drains to a standstill. Pipe Material Choices DWV pipes are not under great pressure…
…thing as a horizontal waste pipe. All waste pipes must run vertically or…
…also connected to a vent pipe. These secondary vent pipes, formed at the junctions…

Jump To: How To Library » Plumbing » Pipes, Drains & Fittings

…drain management." But that was before I got a glimpse of PF WaterWorks' new product, basically a self-cleaning drain pipe called PermaFLOW . It's difficult to explain how it works, so I suggest you watch their video. This product means no more…

Jump To: Blog » Plumbing

…should overlap. On the new pipe, draw a mark 1/8-inch back from where the two pipes overlap. This will allow…
…Remove the new length of pipe from the freeze-proof…
…6: Prepare the copper pipes. Use emery paper to…
…ends of the new copper pipe. Make sure the sanded…

Jump To: How To Library » Plumbing » Faucets

…the water delivery pipes to control water pressure. The smaller the pipe diameter, the higher…
…system, for example, pipe of increasingly smaller…
…for as the supply pipes branch out from the…
…should be placed, what pipe materials can be used…
…needed to safely join pipes or create branches…

Jump To: How To Library » Plumbing » Miscellaneous Plumbing

…answer. Water Burst pipes, leaks, preparation…
…look for the main inlet pipe, which may have a faucet…
…place where the inlet pipe enters the home. Often…
…between the tank and the pipe that feeds the rest of…
…drain the water in the pipes as well by opening a valve…

Jump To: How To Library » Safety