…sizes and spacing used to attach the sheathing to the roof's structural members…
…not provide enough strength to keep the sheathing on during an intense windstorm. Before…
…devastated South Florida in 1992, roof sheathing was generally attached using 6d nails…

Jump To: How To Library » Roofing » Flashing & Sheathing

Often carpenters will make quick work of cutting fiberboard sheathing by making their cut marks with a chalkline instead of a carpenter's pencil. Hook the end of the chalkline on one end, hold…

Jump To: How To Library » Carpentry » Carpentry Cuts

…directly over an ice-and-water barrier to seal the roof sheathing and protect against the elements. Synthetic underlayments…
…provides a vital second layer of protection on top of the sheathing to help keep moisture out. It is necessary for roofing manufacturers…

Jump To: How To Library » Roofing » Flashing & Sheathing

…panel joints to keep out the rain if the roof covering is lost. The Peel & Seal tape seals the joints between the TechShield sheathing panels so rain won't run between them and into the house. Peel & Seal reflects heat to keep interiors cool and to reduce…

Jump To: How To Library » Roofing » Flashing & Sheathing

The Habitat for Humanity team moves ahead on the roof. This time it's sheathing and applying shingles. Deane Evans of PATH and Ren Anderson from the National Renewable Energy Lab talk to Bob about some special…

Jump To: Bob on TV » Home Again » Habitat for Humanity

…the necessary seismic straps over the sheathing. They say that you can install the T1…
…which rise about 1/8" above the sheathing. My concern is that if you place the…
…straps it will not sit flush against the sheathing and you will have an air gap. One solution…

Jump To: Bulletin Board » Roofing and Siding

…diferently here. They use Thermo-Ply instead of plywood and wait until the house is completley framed before sheathing and the sheathing is usually subcontracted out. Do you have any insight on why the different proceedures and benefits of it…

Jump To: Bulletin Board » Roofing and Siding

…relatively common practice to lay new sheathing over old, but I don't like it, and…
…all the old roof covering, and the old sheathing (delaminated and rotted 3/8 plywood…
…best, it is a spacer between the new sheathing and the rafters onto which the new sheathing…

Jump To: Bulletin Board » Roofing and Siding

…We opted to have the radiant barrier sheathing installed. We were told the brand they…
…installed two different randiant barrier sheathing brands; Norbord and Weyerhaeuser…
…brands were installed? 3) Regarding sheathing installation, it is ok to see light…

Jump To: Bulletin Board » Construction Project Blog

…used between the insulation and the backerboard for the tiled walls. There is a small amount of mold on the paperbacking of the sheathing. I only affected the area of the shower and extends up about a foot. Can this be safely cleaned?

Jump To: Bulletin Board » Safety, Environmental and Hazardous Materials