BobVila.com

…system features fully trimmable joists that are ordered to length…
…by the manufacturer. These joists feature an open-webbed design…
…pipes to be run through the joists, without the need for a drop…
…provide an even, continuous nailing surface, these panels are…

Jump To: How To Library » Special Features » EnergyWise House

…objects may require additional joists and larger beams. Local building…
…butt-jointed board ends over joists. Beam span is the distance…
…pieces 2x4 8 feet Joists 4 pieces 2x8 8 feet…
…6 Concrete footings with nailing blocks

Jump To: How To Library » Deck, Porch & Patio » Deck

…the ground and standing them up. The unevenness of the ceiling joists and walls demands that the framing be "stick built" with each stud individually measured and cut before nailing it in place. This is accomplished in the following three stages…

Jump To: How To Library » Framing » Miscellaneous Framing

…hardwood floors. The most common is blind nailing, often used with 2-1/2-inch, tongue…
…and plugs. When completed, both blind nailing and screws and plugs hide the fasteners from view. Face nailing, which leaves the fasteners visible on…

Jump To: How To Library » Floors » Wood Floor

…carefully located beneath upper level floor joists. The upper level's floor joist's…
…is a measure of the distance the floor joists can run without additional support form…
…including engineered lumber, truss-joists, micro-lams, glulams, LVL's, heavy…

Jump To: How To Library » Walls & Ceilings » Walls » Miscellaneous Walls

…second-generation composite material. Your substructure may still be pressure-treated wood and the rafters and ceiling joists will be wood, but all your trim boards like the eaves, soffits and fascia can be synthetic, says Tatsch. It eliminates the…

Jump To: How To Library » Deck, Porch & Patio » Porch

…for fit. When installing a prehung door, it's important to shim behind the hinges and check for level and plumb before nailing. Cutting to Fit Once it's cut to the proper width, it's time to cut it to length or width. Cutting the bottom…

Jump To: How To Library » Doors » Interior Doors